|
这是我之前做的，IBM返回的邮件内容：
World Wide Name Transaction Key License Key Feature Name
10:00:00:60:69:c0:d1:05 AA364B6778C9996D1694ED cQyyQycbQQfRzzRu ZONING, FABRIC WATCH, FULL FABRIC
10:00:00:60:69:c0:cd:17 A797FB4165C3B2E9138C5A ccde9b9SRfdefA2 ZONING, FABRIC WATCH, FULL FABRIC
Installation Guide
Note: The following instructions assume the switch has been attached to a network and is accessible from your PC or workstation.
Via telnet
Connect to the switch via telnet session from a terminal emulation program initiated on a PC or workstation on your network.
Type the command: telnet [switch IP address]. When prompted, enter Administrator User name and password.
After login, enter the command: licenseAdd "license-key" (quotes are needed for this command). Be sure to enter the license key value exactly as received.
Check the status of installed license features by entering the command: licenseShow. This command displays a list of all licensed features enabled on the switch.
From a web browser (via GUI)
Connect to the switch with your browser. From the Switch view, select the Admin button.
When prompted, enter administrator user name and password.
On successful login, you will be presented the Admin screen, select the License Admin tab, Enter the new License Key. Be sure to enter the license key value exactly as received.
Select the Add License button.
To validate that this LicenseKey has been installed
From front panel display - if your switch is a model with a front panel display, the WWN can be shown on the display. Select the following command sequence: Status Menu > WorldWide Menu.
Further information
Consult the manual for the feature you are installing for further information on installation and answers to specific questions on the application.
Troubleshooting Guide
The license key is not accepted. Validate that the license key was entered exactly as received with no extraneous characters and following the correct use of capital and non capital letters. Re-enter the key and re-type the command licenseShow.
The license key was accepted, but does not appear to be active. This error will occur if a license key was entered on a switch with a different World Wide Name than intended. Check the World Wide Name on the switch by using the command: switchShow
To obtain the World Wide Name of the switch:
Connect to the switch from a terminal emulation program via telnet [telnet (switch IP address)].
When prompted, enter the administrator user name and password.
Enter the command switchShow. This command displays information about the switch, including the WWN. The WWN is in the form 10:00:00:xx:xx:xx:xx:xx where 'xx' values are unique to each switch.
Select Continue to obtain additional activation keys or correct input errors; otherwise, you are done with this procedure.
|
